WD20EARS 60MVWB0 SA OK. head test OK But can't Read LBA .???

[cuumaytinh]

WD20EARS 60MVWB0 SA OK. head test OK But can't Read LBA .???

SA test OK.

HEAD test OK.

but :
Translator regeneration
Regeneration method..................... : Use P-List only
P-List Copy 0........................... : Ok
P-List Copy 1........................... : Ok
Error Code : 3C15....................... : FMT PLIST PSN OUT OF RANGE


ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
ROM version............................. : 22.00E
ROM generation.......................... : 22.01E
Link table version...................... : 0B.36.
Consolidated ROM version................ : 00220000

ROM Modules:
Flash ROM dir reading................... : Ok
Flash ROM dir reading (Ext)............. : Ok (Active)
Modules directory address............... : 377 654
SA regions address...................... : by default
SA Translator loading................... : Ok

Heads configuration..................... : by map
Heads number............................ : 6
Heads number in use..................... : 6
Switched off heads...................... : No
Heads map............................... : 0,1,2,5,6,7
ROM Firmware version.................... : 00220000

Service area:
Permanent overlay....................... : Loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : Copy 0,Copy 1

Configuration reading................... : Ok
Master Password......................... : has not been set
User Password........................... : has not been set



Heads test
Cylinder to test........................ : -100
Heads to test........................... : 0,1,2,5,6,7
Head 0.................................. : Ok
Head 1.................................. : Ok
Head 2.................................. : Ok
Head 5.................................. : Ok
Head 6.................................. : Ok
Head 7.................................. : Ok
any solution . thanks for alll

[cuumaytinh]

My P-list adn translation

[GuideRecovery]

probably weak heads
did you try to image with selective heads

[cuumaytinh]

probably weak heads
did you try to image with selective heads

Yes. i did !. But not works

[GuideRecovery]

try changing the head map to 1,2,3,5,6,7 > soft reset and than change it back to original 0,1,2,5,6,7
see if it works

[AJ2008]

Try to set all heads to '0' then after soft reset try to read sector with H0. If no success, repeat with '1'. Do this because it is impossible to see which head is damaged, and heads 0 + 1 are SA heads.

[cuumaytinh]

i was change good head from donor HDA but . no thing change !! .
can by P-list Error ??

[AJ2008]

If translator is good then plist should not be so important. did you check all SA modules for any errors before you changed heads? does it ID well?

[cuumaytinh]

If translator is good then plist should not be so important. did you check all SA modules for any errors before you changed heads? does it ID well?

But Transkator error .
now i want to translator regenator . But it show error.

i try . Write Module 33 (P-list) to Good donor driver and transtator regenator . But it same error .
I think problem at plist.
"Error Code : 3C15....................... : FMT PLIST PSN OUT OF RANGE"

or some address of sector in plist error ????????????????