WD10JPVX-60JC3T0 - 6 buzz/beeps on power on

[DCC-PC3K]

Hi All,

I have a WD FBLite 2.5" hard drive (WD10JPVX-60JC3T0) when it is powered on the drive buzzes/beeps 6 times before DRD + DSC is lit, but also ERR and AMN.

Auto detect works and detects the model/family, but defaults to starting in kernel mode and no HDD info is displayed.

Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 256

ROM:
Read ROM................................ : Ok
ROM Data size........................... : 256 Kb
Flash ROM dir reading................... : Ok
Flash ROM dir reading (Ext)............. : Ok (Active)
Modules directory address............... : 159 040
SA regions address...................... : shifted
Module 02 access........................ : Granted
SA Translator loading................... : Ok

ROM Modules:
ROM version............................. : 16.7CG
ROM F/W version......................... : 0016007C
Overlay F/W version..................... : 16.7CG
Servo F/W version....................... : N0.41

Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3



I have tried advice from previous questions such as blocking SA access and uploading LDR and firmware of a suitable donor into ram, etc; which gives the XYZ model but no capacity.

Trying to run a heads test after performing this gives "ERR DISK SERVO ACTUATOR AI TIMEOUT". Would the slow drive fix offer any solution, or is there anything else I could try?

Thanks!

[d_d_recovery]

Put your ear to the drive and switch it on. Does it beep without spinning?
What you are seeing is the PCB info, not the actual drive SA.

[Maxim_TS]

Heads may be parked on platters, need to open the drive in clean box and check inside.