MP0603H translator issue?

[pcimage]

Hi!



Got one of these in, with the typical Magma v3 PCB problem, not quite spinning up to speed.



Replaced PCB with one of same FW (UD100-11) and it spins up but stays BSY. Terminal looks normal but it never gets to "ENG>" prompt just sits there.



So, I hot-swapped to get modules and performed a smart hot swap after copying the appropriate modules to a donor.



All looked good up untill ~10.5 million sectors, then not one readable thereafter.



Head config is the same (i.e. 1,0,3 - H2 missing)



Now to me this looks like a translator issue but these have dynamic translator, right?



Not had a Samsung with this sort of issue in before.



Any ideas?

[pcimage]

Repaired original PCB, problem solved