WD1600BEVE - 22WZT0

[Towerrat79]

Hello
I have a WD1600BEVE - 22WZT0 Which makes a sound as if wire were either breaking or hitting the top of the case. When

I ran PC 3000udma in McKinley mode I receive the following information:

Techno mode key:

Tech on................................. : Ok

ROM:
ROM Data size........................... : 192 Kb
ROM reading............................. : Ok
ROM version............................. : 01.09A
ROM generation.......................... : 01.09A
Link table version...................... : 01.27.
Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 3
Switched off heads...................... : Yes
Head map................................ : 0,1,2

Firmware version........................ : 00010009


Techno mode key:
Tech on................................. : Ok

RAM:
Zone allocation table................... : HDDs RAM reading error Techno CMD sending error Device Error Detected 51/04 (ABR)
Drive is not ready
SA SPT.................................. : SA SPT determination error Techno CMD sending error Drive is not ready

Head number reading..................... : Ok
Heads number............................ : 3

ROM:
ROM Data size........................... : 0 Kb
ROM reading............................. : Ok
ROM version............................. : 01.09A
ROM generation.......................... : 01.09A
Link table version...................... : 01.27.
Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 3
Switched off heads...................... : Yes
Head map................................ : 0,1,2

Firmware version........................ : 00010009

Service area:
SA dir reading.......................... : Unknown error. Code(0)
SA Copies avalabled..................... : NONE

Configuration reading................... : Module 02 not found

Translator regeneration
Regeneration method..................... : Use P-List only
HDD Readiness timeout (10000 ms) D0 / 00
Heads test
Cylinder to test........................ : -10
Heads to test........................... : 0,1,2
Drive is not ready
Head 0.................................. : Error W : 1
Head 1.................................. : Skip
Head 2.................................. : Skip


Running DataExtractor I received the following
---------------------------
PC-3000 UDMA
---------------------------
The drive does not support LBA mode or the ID Drive was read incorrectly!
---------------------------
OK
---------------------------

What would my next step be?
Thanks
Frank

[Igor]

Hello Towerrat79,

The problem into this case should be in PCB.
You should to find a donor drive for HotSwap.
If you want to know more about HotSwap you can read our utility for Western Digital 8.4 HOT-SWAP method.

REgards.

[Towerrat79]

Igor
Thank you for the reply. For my knowledge, where did you see that the PCB should be the component that is causing me problems?

Frank