Maxtor 6E040L0 module 18 and 78 errors

[Nova]

Hi guys

Need help on Maxtor 6E040L0510, it has module 18 (UBA 41) error and also Module 78, I tried regenerate but didnt work.

I can switch the drive to ALT-SA all modules are ok, and can I rewrite module 18 and 78 from ALT-SA to the faulty module 18 and 78?

Thank you for any help.

[Alex Ivlev]

You need tests->Service information->Work with service area->SA structure test, and send it to ts2@acelab.ru. What have you done with this drive?

[AJ2008]

I disagree. I think that module 18 and 78 will be repaired if you run tests->Service information->Work with service area->SA Surface Verification.

Then select Module Recovery from SA menu to repair PLIST (18). Then set to Master, disk should ID ok then run Translator Regeneration.

[Pepe]

Hi

Alt SA (SA C) mod 18 and 78 are not appropriate for SA A.

If the drive can write its SA correctly (SA write test passes), U can try rewriting these modules to get rid of the reading error, then regenerate the translator.
if it doesn't work, I mostly use smart hotswap.

pepe

[AJ2008]

Hi guys

Need help on Maxtor 6E040L0510, it has module 18 (UBA 41) error and also Module 78, I tried regenerate but didnt work.

Seems that the fault is with main SA not Alt-SA.

If SA Surface Verification fails, and modules cannot be written as pepe suggests, then HotSwap will be only way to get data back

[Nadpc3k]

i have the same problem ... for hot swap which module i need from the patient drive... all of them or some slected one ?