Wd USB 3.0 Detected but shows error code 4f10

[Arihant]

I have one wd10jmvw-11ajgs1 hdd. It is detecting perfectly but does not find Family type in WD usb utility.

I have converted it in sata after that it shows error
"HDD Ram's Reading error - device erro detected " Error code :4f10"

what is mean by Error code 4F10.
How to take SAbackup.

Thanks,

[AJ2008]

It means SA is encrypted and vendor commands are blocked. This is common on new models like Firebird LT.

[Arihant]

Means - Sata conversion will not work for this type of hdd.

The Hdd has one head damage. I would like to disable it in Ram.

What will be solution?

Thanks,

[AJ2008]

It is possible to reach SA and RAM/ROM but I think its not possible to adjust head map in RAM with drive initialise normally. Maybe key is to find some non SA-encrypting model that you can write patient adaptives only to then hotswap, but so far I have not tried this...

[Arihant]

Which family it belogs to. Is any hints to search non encrypted SA hdd for donor.

thanks,

[AJ2008]

Firebird LT I think this model is. Maybe you could HS with firebird (non-LT) which I guess would not have encrypted SA

[Arihant]

Searching the donor hdd

[houman_2h]

Start the drive in Kernel mode
Block SA access
Load DIR in RAM
read module by ID

[odedshankar]

I have got the same issue.
Did you manage to gain access to SA?
How do you block access to SA in kernel mode?

[odedshankar]

Will hotswap with similar donor will give me access to the SA?
or each drive has a unique key for its SA?

[einstein9]

Hotswap will NOT work with encrypted SA
tried already long time.

[houman_2h]

I have got the same issue.
Did you manage to gain access to SA?
How do you block access to SA in kernel mode?

place a paper under the MHA connector

[pclab]

Today I got the same error, after a PCB swap...
I'll try your suggestions.
An answer from ACE support would also be great...

Edit: The paper under the MHA didn't solved...

[AJ2008]

Today I got the same error, after a PCB swap...
I'll try your suggestions.
An answer from ACE support would also be great...

Edit: The paper under the MHA didn't solved...

short read channels

[houman_2h]

Today I got the same error, after a PCB swap...
I'll try your suggestions.
An answer from ACE support would also be great...

Edit: The paper under the MHA didn't solved...

Short E47 PCB to the ground