We can connect terminal to Samsung USB drives using diagrams below
For MT1
- MT1.png (181.88 KiB) Viewed 8844 times
For M7S2
- M7S2.png (173.8 KiB) Viewed 8844 times
Sometimes we need to connect SATA interface to USB PCB. We can do it using next diagrams
This is schema of SATA connector
- SATA.jpg (21.74 KiB) Viewed 8844 times
We should solder it on the place of 4 capacitors between SATA chip and USB chip. Capacitors should be unsoldered before.
When you unsolder one capacitor you get 2 pins. One goes to main chip and second goes to USB chip. So when we will unsolder 4 capacitors we will get 8 pins. We should solder sata connector to 4 pins that go to main chip.
On the diagrams below we can see places of capacitors (they are marked by red rectangles) and digits.
Pins number 3, 2, 5, 6 of SATA connector should be soldered to appropriate (by written digits) pins on the pcb.
Schema of MT1
- SATA MT1.png (187.05 KiB) Viewed 8844 times
Schema for M7S2
- SATA M7S2.png (164.49 KiB) Viewed 8844 times
Schema for M7E
- SATA M7E.png (133.62 KiB) Viewed 8844 times