MP0603H translator issue?
Posted: 22.01.10, 12:57
Hi!
Got one of these in, with the typical Magma v3 PCB problem, not quite spinning up to speed.
Replaced PCB with one of same FW (UD100-11) and it spins up but stays BSY. Terminal looks normal but it never gets to "ENG>" prompt just sits there.
So, I hot-swapped to get modules and performed a smart hot swap after copying the appropriate modules to a donor.
All looked good up untill ~10.5 million sectors, then not one readable thereafter.
Head config is the same (i.e. 1,0,3 - H2 missing)
Now to me this looks like a translator issue but these have dynamic translator, right?
Not had a Samsung with this sort of issue in before.
Any ideas?
Got one of these in, with the typical Magma v3 PCB problem, not quite spinning up to speed.
Replaced PCB with one of same FW (UD100-11) and it spins up but stays BSY. Terminal looks normal but it never gets to "ENG>" prompt just sits there.
So, I hot-swapped to get modules and performed a smart hot swap after copying the appropriate modules to a donor.
All looked good up untill ~10.5 million sectors, then not one readable thereafter.
Head config is the same (i.e. 1,0,3 - H2 missing)
Now to me this looks like a translator issue but these have dynamic translator, right?
Not had a Samsung with this sort of issue in before.
Any ideas?
