PC-3000 Forum

dear all ,
I have wd2500aajs-65m0a0.drive id cant get.in log it shows no sa copy available,when i start drive in normal mode it get spt 1311 and becomes ready.i can test modules too but by id only.there i found ata mod bad.so i need it if somebody know to reallocate this mod to another good mod plaece i think drive should work.i cant find mod for this anywhere so i came to forum.if somebody help me than pls i m waiting.

Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 2
Cyl Count............................... : 170

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
ROM version............................. : 01.CSE
ROM generation.......................... : 01.CSE
Link table version...................... : 03.09.
Consolidated ROM version................ : 000100CS

ROM Modules:
Flash ROM dir reading................... : Ok
Modules directory address............... : FIXED
SA regions address...................... : by default

SA Translator loading................... : Ok

Heads configuration..................... : by map
Heads number............................ : 2
Heads number in use..................... : 2
Switched off heads...................... : No
Heads map............................... : 0,1
ROM Firmware version.................... : 000100CS

both the heads are ok as i test head.
in sa structure test report only mod 11 is bad.cant copy it.i have sa region backup to but even in sa region there is no mod 11.i have check in same pinclite family diffrent model ,size of ata mod 11 is 210-250 kb. in my model it shows 431kb

11.rpm

hi maxim,thanks for replying but do you have rom and other mod with you.than pls send it to me.If i write this mod to hdd may be differ than i dont have any original mod 11 as i am unable to copy/ read this mod.

Write it to your HDD. Did you make copy of FW after read by ID? If surface looks ok and no damaged area I have potential method for you to make a repair. Other alternative is hotswap, so is important you make SA backup.

But try to write 11.rpm first, if successful will be much simpler