PC-3000 Forum

Dear Friends:


I have a problem
I have a hard drive WD1600AABS-00PRA0 and a same donor.
I've completed the exchange of heads and I failed to recovering the data.
When a made this change in a clean room and with the right tools, the disc continues with the same problem




The PC3000 shows as folllow:

Techno mode key
Techno mode key......................... : Ok

RAM:
Zone allocation table................... : HDDs RAM reading error Techno CMD sending error Device Error Detected: "VSCE PERM OVL NOT LOADED"
SA SPT.................................. : SA SPT determination error Techno CMD sending error Device Error Detected: "SERVO ERROR CODE BASE SvirActSync"

Head number reading..................... : Ok
Heads number............................ : 2

ROM:
Flash Dir reading....................... : Ok
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
ROM version............................. : 21.8BM
ROM generation.......................... : 21.8BM
Link table version...................... : 22.5C.
Heads configuration..................... : by map
Heads number............................ : 2
Heads number in use..................... : 2
Switched off heads...................... : No
Head map................................ : 0,1

Firmware version........................ : 0021008B

Service area:
SA dir reading.......................... : Unknown error. Code(0)
SA Copies avalabled..................... : NONE

Configuration reading................... : Module 02 not found



Someone can give me some ideas to fix this problem? thank you

CarlosAdolfo