PC-3000 Forum

Hello,

i am a new user of PC3000, i ve some problem with the SA of this drive.
maybe i need to writte modules?

hard drive is detected as: Marvell Tornado

SA SPT: manually, default value 500 doesn't work....

SA tracks, SA Surface, are OK, all in ROM too.
But no modules in SA found.

and here the log at supply:
------------------------------------------------------------------

Techno mode key:
Tech on................................. : Ok

RAM:
Zone allocation table................... : HDDs RAM reading error Techno CMD sending error Device Error Detected 51/04 (ABR)
SA SPT.................................. : SA SPT determination error Techno CMD sending error Device Error Detected 51/04 (ABR)

Head number reading..................... : Ok
Heads number............................ : 6

ROM:
ROM Data size........................... : 192 Kb
ROM reading............................. : Ok
ROM version............................. : 21.68Q
ROM generation.......................... : 21.68Q
Link table version...................... : 22.50.
Heads configuration..................... : by map
Heads number............................ : 6
Heads number in use..................... : 6
Switched off heads...................... : No
Head map................................ : 2,3,4,5,6,7

Firmware version........................ : 00210068

Service area:
SA dir reading.......................... : Unknown error. Code(0)
SA Copies avalabled..................... : NONE

Configuration reading................... : Module 02 not found


------------------------------------------------------------------

thanks, and nice to meet you ACELab community!

Hello d.rob,

SA dir reading.......................... : Unknown error. Code(0)

This error appears because of uncorrect instalation process.
So, reinstall the utility.

Regards

hello!

i've reinstall PC3000 UDMA utility from the CDrom, new act file...etc but the problem of code 0 still, is it an installation problem at 100% ?? the hard drive is a marvell familly, tornado. maybe tornado is not supported, or less than others.

Hello d.rob,

Could you publish a report after:
1) trecks reading(except - 1)
2) checking LBA range(from 0 to 9)

Regards