Firebird 2.5 USB, Module ID 0B reading error

[bvreddy]

Hello
Firebird 2.5 USB detected fine , but unable to access modules & data.
PCB is isolated , its good.
Module 0B is written from same family successfully, but same error messages.



Log details:

Model : WDC WD10JMVW-11S5XS0
Serial : WD-WXC1A1350232
Firmware : 01.01A01
Capacity : 931.51 GB (1 953 525 168)



Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 1437

ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
ROM version............................. : 03.78C
ROM generation.......................... : 03.79C
Link table version...................... : TP.4D.
Consolidated ROM version................ : 00030078

ROM Modules:
ROM reading............................. : Module ID 0B reading error; unexpected error: No data been read
ROM Firmware version.................... : Module ID 0B reading error; unexpected error: No data been read

Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ABA/CHS)................ : Device error detected
SA Access............................... : NONE

Configuration reading................... : Module 02 not found



need help...
B.V.Reddy