PC-3000 Forum

important information came without hdd rpm (rpm = 0) was opened and the heads were not in the area we turn our heads resting area for the rest ... at least three times each hdd recognized and read your id (model, serial number, fw) but not given access to the terminal or the modules ... Now hdd to turn this log below:

Hi to all!!

Rst 0x20M
RW: Disc Ctlr Initialization Completed.
(P) SATA Reset


status register DRD DSC

NO read model and serial and fw
HDD ID no read...
modules no detected....
no sound strange, and always the same log reported
no access in terminal (ctlr+z)
no busy

??

hello.

Try to catch the moment after hard drive goes ready and press "i' button on top panel(utility status).
If new window will appear, hit refresh button and see if modules were detected(log tab will show the output)