Page 1 of 1
PC-3000 UDMA Error
Posted: 16.11.07, 18:24
by DR_Ireland
The specified module could not be found
I am getting this error when I try to load utility for FUJITSU drives
Is there anything I can do oro do I have to reinstall the utility?
Posted: 22.11.07, 10:16
by ACE_Admin
what your version ? Have you updated it ?
Posted: 22.11.07, 14:52
by DR_Ireland
Just did an update but it wants to activate again (that's whay I wanted to avoid). Waiting for activation file, I hope it would help.
Posted: 06.12.07, 14:47
by DR_Ireland
Same problem again. It was working fine few minutes ago and when I closed Utility and opened it again I am getting same error but this time for almost all manufacturers. What could that be?
PC is working perfectly, checked RAM and HDD - no errors. I don't have any problems with a no other software here...
programme version:
Product: PC-3000 (PC3000 UDMA (Kernel))
version: 3.21
Build: 3.2.1.2486
Product: Data Extractor UDMA
version: 3.31
Build: 3.3.0.1001
Posted: 07.12.07, 15:50
by DR_Ireland
Again I had to reinstall the utility but I am wondering what could be causing these problems...