PC-3000 Forum

I've read some articles in the blog but I was unable to obtain any success.
What I did is a surface test, remove interactions and intersection, add defects into P-list and regenerate translator.

After turning off the hard disk and re-run the utility I do another surface test and I get the same defects, it's seems to me that anything is changed into P-list.

What is the correct procedure to add defects into P-list?

Thanks in advance

ictsec.areait, try to hide the defects not by sectors, but by tracks into P-List. Also clear Relo-List and G-List.

Maxim_TS wrote:Source of the post ictsec.areait, try to hide the defects not by sectors, but by tracks into P-List. Also clear Relo-List and G-List.

Max ,
Also Necessary to Zerofill Drive After Such Procedure