What is the procedure to add defects into P-list?

A place to discuss all topics that do not meet the rest of the conference

Moderators: Roman_TS, Maxim_TS


ictsec.areait
Newbie
Posts: 15
Joined: 01.08.16
Reputation: 1 / (14)

What is the procedure to add defects into P-list?

Postby ictsec.areait » 19.01.17, 09:07

I've read some articles in the blog but I was unable to obtain any success.
What I did is a surface test, remove interactions and intersection, add defects into P-list and regenerate translator.

After turning off the hard disk and re-run the utility I do another surface test and I get the same defects, it's seems to me that anything is changed into P-list. :shockable: :???:

What is the correct procedure to add defects into P-list?

Thanks in advance :)


Maxim_TS
Site Admin
Posts: 348
Joined: 27.03.13
Reputation: 17 / (166)

Re: What is the procedure to add defects into P-list?

Postby Maxim_TS » 19.01.17, 13:44

ictsec.areait, try to hide the defects not by sectors, but by tracks into P-List. Also clear Relo-List and G-List.
With best regards
ACELab technical support
ts.acelaboratory.com
blog.acelab.eu.com

User avatar
Amarbir[CDR-Labs]
Advanced user
Posts: 768
Joined: 03.08.09
Reputation: 8 / (78)

Re: What is the procedure to add defects into P-list?

Postby Amarbir[CDR-Labs] » 23.01.17, 17:28

Maxim_TS wrote:Source of the post ictsec.areait, try to hide the defects not by sectors, but by tracks into P-List. Also clear Relo-List and G-List.


Max ,
Also Necessary to Zerofill Drive After Such Procedure
Regards
Amarbir S Dhillon ,CDR Labs [ Chandigarh ,India ]
DataRecovery - The Affordable Way In India
Visit - > http://www.chandigarhdatarecovery.com My Facebook - > https://www.facebook.com/chandigarhdatarecovery


Return to “Discussion club”

Who is online

Users browsing this forum: No registered users and 1 guest