No connection
Posted: 18.09.24, 08:43
I have a microsd Card Type 1
I soldered it on the circuit board as done on the description.
But I am not possible to read the chip ID correctly.
Is there a solution for this problem?
Best regards
I soldered it on the circuit board as done on the description.
But I am not possible to read the chip ID correctly.
Is there a solution for this problem?
Best regards
Attachments
- PXL_20240918_061339730.jpg (2.96 MiB) Viewed 4312 times
- PXL_20240918_061308763.jpg (2.26 MiB) Viewed 4312 times
- PXL_20240918_061300822.jpg (1.96 MiB) Viewed 4312 times