I have a microsd Card Type 1
I soldered it on the circuit board as done on the description.
But I am not possible to read the chip ID correctly.
Is there a solution for this problem?
Best regards
No connection
Moderators: Nick_TS, Roman_TS, Filipp_TS
No connection
- Attachments
-
- PXL_20240918_061339730.jpg (6.07 KiB) Viewed 83 times
-
- PXL_20240918_061308763.jpg (5.71 KiB) Viewed 83 times
-
- PXL_20240918_061300822.jpg (12.91 KiB) Viewed 83 times
Re: No connection
Most probably soldering is bad and you have some shortage. Check it with multimeter.
Return to “Monolithic devices recovery”
Who is online
Users browsing this forum: No registered users and 33 guests