Which adapter to use, TLGA-52?

[oldman]

Hello,

I have a NAND chip from a SKhynix,
H2JTFG8YD1BMS
BC A0 441A

Photo attached.

Which adapter to use?

TLGA-52?

Thanks.

Phil

[Roman_TS]

Hello!

This is TLGA-60 - it has 8 addition pins in central raw. You can try to read it with TLGA-52, but there might be issues.

[Jaime]

Hello Oldman,
I have the same problem,
I need to read the Nand chip H2JTFG8YD3MBR, this is too TLGA-60.
Could you to read the chip with apdapter TLGA-52?

Thank and regards.

[Roman_TS]

For reading BGA-60 with TLGA-52 adapter, you have to chose reading scheme number 1785, and ignore all others during chip reading. It will help.

[Amarbir[CDR-Labs]]

Source of the post For reading BGA-60 with TLGA-52 adapter, you have to chose reading scheme number 1785, and ignore all others during chip reading. It will help.

Well,
if i was at his place i will hardwire the chip to a monolith board

[AJ2008]

I have never had success reading in TLGA-52 reader, but I only see this a small number of times so is not a problem to wire manually for reading

[oldman]

Sorry for the delay as it is such old post, seem that I was not able to read and recover it successfully.

[Jaime]

Hello,
I can not read it,
what is the pinout of the chip, to try to read the chip

Thanks