PC-3000 Forum

hello all,
where i can connect RxD and TxD signal for terminal on Samsung MZ7TE512HMHP 2.5" SATA PM851 Family ?

Hello! Those two pins in the top of the board are the pins for terminal connection.

yes Mr. Roman.
which is TX and which is Rx pin ?
i show you in this attachment pic. if i wrong please correction. ok ?

Need to check it by yourself. Try both combinations. In Samsung Utility, should be a picture with correct PIN placement.

hi Mr. Roman,

it need to check it by myself about which TX and which is Receive side ? how if i wrong rx and tx side. what happen if wrong side?

Nothing will happend. If you will connect terminal wrongly - SSD will not detect terminal.

Case is recovered in ACE Lab TS

hello Mr. Roman.

o yes, thanks very much for you and for your good tool to recover this case.

another problem. how to low level format this pm851 ?
in terminal appear these :
Selected family......................... : Samsung 840 EVO series
Controller.............................. : S4LN045X01-8030

Techno mode key......................... : Techno mode error; unexpected error: Device error detected - Device error detected - Device error detected - Device error detected

SSD status:
SSD is in ready state................... : Yes
SSD is locked........................... : No
SSD is in Safe Mode..................... : Yes
Loader uploaded......................... : No
Logical access is possible.............. : No
Physical access is possible............. : No

Loader uploading
****************************************
Code name............................... : 840EVO.ldr

Write HDD microcode
Waiting 2 sec.
Ready state waiting..................... : Ok
Write Main Firmware..................... : Ok

SSD status:
SSD is in ready state................... : Yes
SSD is locked........................... : No
SSD is in Safe Mode..................... : No
Loader uploaded......................... : Yes
Logical access is possible.............. : No
Physical access is possible............. : Possibly
****************************************

Reading password information............ : Ok
USER password........................... : No

Command execution is not possible because of logical access is not available!

i have been plug Tx and Rx.

Firmware update with _FORMAT option will allow to erase all user data and restore SA to default settings.

Yes. You r right. you make this ssd pm851 be new again. thx alot for you and pc-3000 ssd

hi Roman
can't find menu FW update menu (just reading and writing in FW menu)

Logical access is possible.............. : No

can't clear pass

tks

Hello. About all technical questions better create ticket in our TS department. Thanks

jinarto wrote:Source of the post hi Mr. Roman,

it need to check it by myself about which TX and which is Receive side ? how if i wrong rx and tx side. what happen if wrong side?

Roman ,
It Was Me Who Motivated To Update His Pc 3000 ,I Now Have 5 People In My Kitty Whome i Have Refered And they Have Purchased New or update there pc 3000 tools