OCZ VT180 - Attention! There is zero block size for chip with id 0x408D07A93A43A98 in NAND flash chiPS data base of PC3K

Moderators: Roman_TS, Filipp_TS, Sergey_TS


-BR-
New user
Posts: 79
Joined: 18.12.08
Reputation: 2 / (20)

OCZ VT180 - Attention! There is zero block size for chip with id 0x408D07A93A43A98 in NAND flash chiPS data base of PC3K

Postby -BR- » 12.10.19, 00:04

After power on SSD became ready, but get BSY forever after any command (i.e. read HDD ID)

Controller chip:
INDLINX
IDX500M00-BC
P3TG08.00

After jumper short and power on, Hdd enters SAFE mode it detects as:

Model : BAREFOOT3-FACTORY-ROM
Serial : 0123456789abffbf2444
Firmware : 00.P80
Capacity : 137 GB (268 435 456)

On PC3K SSD I Select OCZ > Vector 180 series > Safe mode and perform requested short

Terminal messages:
---------------
Tech-key - OK
Attention! There is zero block size for chip with id 0x408D07A93A43A98 in NAND flash chips data base of PC3000

Nand page read error, chip=o page=0x00000004 size=0 options=2: DMA Ext Reading error UDMA Stop error: DA=0;CS0N=[1];CS1N=[1]; .... (more)
Power off
Power on
Write RAM error: Write sector error HDD Data Timeout
------------------
endless looop from here on repeating last 4 messages

Nand page read error, chip=o page=0x00000004 size=0 options=2: DMA Ext Reading error UDMA Stop error: DA=0;CS0N=[1];CS1N=[1]; .... (more)
Power off
Power on
Write RAM error: Write sector error HDD Data Timeout
Nand page read error, chip=o page=0x00000004 size=0 options=2: DMA Ext Reading error UDMA Stop error: DA=0;CS0N=[1];CS1N=[1]; .... (more)
Power off
Power on
Write RAM error: Write sector error HDD Data Timeout
...

Already seen video https://www.youtube.com/watch?v=Wxrg_helKLE
Already read blog page https://blog.acelaboratory.com/pc-3000-ssd-ocz-family.html

Any advice on how to recover data?
Thank you

User avatar
Roman_TS
Site Admin
Posts: 731
Joined: 09.02.11
Reputation: 26 / (262)

Re: OCZ VT180 - Attention! There is zero block size for chip with id 0x408D07A93A43A98 in NAND flash chiPS data base of

Postby Roman_TS » 12.10.19, 14:25

Hello. This model of drive is not supported officially. I already reply you in ticket. If you want to recover it - you can try to send this drive to Prague, we will check the possibility to add it in support list.
With best regards
ACELab Technical Support
ts.acelab.eu.com
blog.acelab.eu.com


Return to “Vector 180”

Who is online

Users browsing this forum: No registered users and 1 guest