PC-3000 Forum

I have one ssd 480GB KINGSTON SA400S37 and it stays in READY STATE and show ID:
PS3111
FW: SBRM02.0
20MB

Do you have any solution?

Hello,

PS3111 will appear in support list during next 4-6 weeks.

i have GIGABYTE SSD 1TB PS3111 FW.SBRM02.0
Read Capacity 20MB
can't get find this FW in ps3111
and it get bsy after start read chip info after upload any FW different

mostafa1 wrote:Source of the post i have GIGABYTE SSD 1TB PS3111 FW.SBRM02.0
Read Capacity 20MB
can't get find this FW in ps3111
and it get bsy after start read chip info after upload any FW different

Hello. You should short the drive in SAFE MODE and keep it shorted all the time. It's important. I recommend you to solder a short wire between pins.

Loader will be automatically highlighted in PC-3000 6.7x.

If you need a help - make a ticket in TS department, our engineers will guide you.

Have anyone found the solution for this???

PS3111-based drives are fully supported since 2018 New loaders appear with the every new software update, so we can support even the latest PS3111 modifications.