Corsair Force LE 200 PHISON PS3111-S11-13

[zeroalpha]

I have been able to image this SDD to approximately 90% complete, however all sectors are zero filled for the full 250GB size. Whats the reason for this to be zero filled? Controller problem causing this type of output?

[Roman_TS]

Hello.

The most probable issue - translator corruption. Drive is working but there is no access to real internal data. Controller return the same pattern - zero filled page.

PS3111-s11 will appear in PC-3000 SSD closer to the Spring 2018

[zeroalpha]

Thanks Roman.

[Amarbir[CDR-Labs]]

Source of the post I have been able to image this SDD to approximately 90% complete, however all sectors are zero filled for the full 250GB size. Whats the reason for this to be zero filled? Controller problem causing this type of output?

Hi ,
I would like to share this with you that you should take a sector at around 25% 50% or 75% LBA of Entire LBA ,then Write Something To That Sector And Save That Sector ,Then Read It If Its Able To Show You The Data You Saved Its Not a Controller Issue Its ZERO Filled Drive

[Abdurrahim.sopon]

Corsair Force LE 200
cpu hison PS3111-S11
suddenly STOPPED working .
ssd is detected with full capacity but all sectors show 00000.
hello everyone
anyone has any real experience with this cpu and same issue ?






Abdur rahim sopon
Dhaka-1205 Bangladesh
mobile:01912-881685
skype:rahim3720
mail:Rahim@datarecoverybd.com
www.datarecoverybd.com
FB https://www.facebook.com/datarecoverybd/
Youtube https://www.youtube.com/channel/UCCoXRtc...GylrNbUq4Q

[Roman_TS]

Abdurrahim.sopon

Hello! This controller us fully supported. Contact ts.acelaboratory.com and our engineer will guide you.

[Abdurrahim.sopon]

Abdurrahim.sopon

Hello! This controller us fully supported. Contact ts.acelaboratory.com and our engineer will guide you.

i was try with PATA adaptor ssd show busy .

but when i connect it sata port it show ready and detected with full capacity .

i try to short pin with PATA Adapter but it always busy .
maybe my short pin out is wrong . (i use points under controller are shorting points)

[Roman_TS]

Abdurrahim.sopon

Please upload the picture how did you connect your drive to PATA adapter.

[Abdurrahim.sopon]

Source of the post

Abdurrahim.sopon

Please upload the picture how did you connect your drive to PATA adapter.

Thank you for your quick reply.
i will upload my PATA Adaptor picture .
Adaptor mcu number : DOF - B75KD0241

i lost my pc3000 IDE adaptor

[Roman_TS]

Abdurrahim.sopon

Try to use other PATA to SATA adapters. This one doesn't work correctly.
But of course, always better to use official ACELab adapter - it always works.

[Abdurrahim.sopon]

Source of the post

Abdurrahim.sopon

Try to use other PATA to SATA adapters. This one doesn't work correctly.
But of course, always better to use official ACELab adapter - it always works.

thank for your suggestion

[rickchbz]

same problem in my patient A400 kingston with ps3111-s11-13, data user zero on extractor

maybe running quick analysis after that

[Roman_TS]

Source of the post same problem in my patient A400 kingston with ps3111-s11-13, data user zero on extractor

maybe running quick analysis after that

You should try to rebuild a translator in utility. If you already try that before, probably it make sense to try with other loaders.