PC-3000 Forum

WARNING! SET FEATURES subcommand required to spin-up after power-up!



Selected family......................... : 7250A7
Model by ID............................. : HGST HTS725050A7E635 OPAL

Techno mode key......................... : Error
ROM reading...
Possible Tech Key is found. Checking...
Result.................................. : Ok

Error executing command: Reading SA [0x3F0000004, 0x4]
Device error detected "ABR"
Error reading module USAG(0): Error executing command: Reading SA [0x3F0000004, 0x1]
Device error detected "ABR"
Error executing command: Reading SA [0x3F0100004, 0x4]
Device error detected "ABR"
Error reading module USAG(1): Error executing command: Reading SA [0x3F0100004, 0x1]
Device error detected "ABR"
Loading modules table................................................. : Error
Error : .............................................................. : Module USAG: no copies read!
Loading the table of "open" modules................................... : Error
Error : .............................................................. : Error executing loading "open" modules dir command



Dear Frds

The above error is coming while accessing hdd ,No head noise in the hdd kindly advise me in this problem

Probably bad heads. If not that, then it's a corrupted modules table, which is even worse.

DataMedics wrote:Probably bad heads. If not that, then it's a corrupted modules table, which is even worse.

how could i fix corrupted modules table ?

Typically you can't.