PC-3000 Forum

hello,
My Toshiba DT01ACA050 (Hitachi ARM 7210DLE6) drive gives the following error on connection. It also do not show the HDD ID.

Selected family......................... : 7210DLE6
Model by ID............................. : <ID IS NOT READ>

Techno mode key......................... : Ok

Error startintg command: Reading SA [0x3F0000004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error reading module USAG(0): Error startintg command: Reading SA [0x3F0000004, 0x1]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x4]
Device error detected (ABR)
Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Error reading module USAG(1): Error startintg command: Reading SA [0x3F0100004, 0x1]
Device error detected (ABR)
Loading modules table................................................. : Error
Error : .............................................................. : Module USAG: no copies read!
Loading the table of "open" modules................................... : Error
Error : .............................................................. : Error executing loading "open" modules dir command


Kindly help.

Well,
Quit Utility Then Try Again Without Power Off ,If SAme Then Change Heads And Try

How does the drive behave, how are heads looking under microscope, is the drive spinning or clicking ?

digitalsupport wrote:Source of the post How does the drive behave, how are heads looking under microscope, is the drive spinning or clicking ?

No there is no noise of clicking and spinning from the drive

I have the same issue. Even with the head changed. No noise. Drive is spinning