PC-3000 Forum

Hello

I have HDD 2,5" Samsung 1TB HM100UX/VP4

The USB connector is very damage...

Any ideas how to solder SATA t this PCB? Or adapt SATA PCB??

regards

Marek wrote:Source of the post Hello

I have HDD 2,5" Samsung 1TB HM100UX/VP4

The USB connector is very damage...

Any ideas how to solder SATA t this PCB? Or adapt SATA PCB??

regards

Yes ,
Can You Post a Clear Image of Both sides Of PCB Please ,You Have PC 3000 ? ,Is your idea to repair or only data recovery

Here comes







I want only data recovery

PC3000? Yes

Hello Marek,

The first image is blured.
So please take a look this article:
http://blog.acelab.eu.com/soldering ... b-pcb.html

Filipp_TS wrote:Source of the post Hello Marek,

The first image is blured.
So please take a look this article:
http://blog.acelab.eu.com/soldering ... b-pcb.html

Filipp ,
I Agree If someone understands and sees a few pcb he can find out the signals from main mcu to usb chip and tap them ,His images were not clear at all

What is not clear at this image? USB port is Gone...

I know how find the signal of USB and SATA brigde...

I try that that You see that capacitors is missing... But Drive is start - motor are start but nothing else

That im looking another way - maybe SATA PCB to adapt to drive...

This is my first HM100UX/VP4

Marek wrote:Source of the post That im looking another way - maybe SATA PCB to adapt to drive...

This is my first HM100UX/VP4

Sir ,
Take Another PCB And Try Out By Swapping Rom To That ,Might Be All of this has lead to some multilayer short or signal failure