PC-3000 Forum

Posted: **05.10.18, 16:14**

I have patient: WD10JPVX-22JC3T0.

The heads seem to be working. HDD becomes ready but the ID is not detected.

I get a such reading in utility (normal mode). How to bite it?

Code: Select all

Techno mode key
Techno mode key......................... : Ok
 
RAM:
HDD Info reading........................ : Ok
Heads number............................ : 4
Cyl Count............................... : 256
 
Zone allocation table................... : HDDs RAM reading error - Device Error Detected: "VSCE PERM OVL NOT LOADED. LDR Upload is recomended"
 
ROM:
ROM reading............................. : Ok
ROM Data size........................... : 256 Kb
ROM version............................. : 16.0TG
ROM generation.......................... : 16.0TG
Link table version...................... : N0.18.
Consolidated ROM version................ : 0016000T
 
ROM Modules:
Flash ROM dir reading................... : Ok
Flash ROM dir reading (Ext)............. : Ok (Active)
Modules directory address............... : 161 929
SA regions address...................... : by default
SA Translator loading................... : Ok
 
Heads configuration..................... : by map
Heads number............................ : 4
Heads number in use..................... : 4
Switched off heads...................... : No
Heads map............................... : 0,1,2,3
ROM Firmware version.................... : 0016000T
 
Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : NONE
 
Configuration reading................... : No SA copy avalabled

Posted: **05.10.18, 16:21**

AdasRip wrote:Source of the post Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : NONE

Try to load Loader and check SA structure looks ok

Posted: **06.10.18, 12:33**

here is what you can do:

1. Block SA Access in ROM
2. Start Utility in Kernel Mode
3. Load Ldr+Dir from SA
4. Start utility in normal mode

see if you can access modules now, if yes check SA structure.

Posted: **16.10.18, 15:55**

Thank you for your help.
I've loaded module 11 from here and it works:
http://files.hddguru.com/download/PC-30 ... 3C2588.rar

PC-3000 Forum

Fblite WD10JPVX - ID is not recognized

Fblite WD10JPVX - ID is not recognized

Re: Fblite WD10JPVX - ID is not recognized

Re: Fblite WD10JPVX - ID is not recognized

Re: Fblite WD10JPVX - ID is not recognized