PC-3000 Forum

Diablo3s
Drive busy
If isloate then busy
If kernal mode then read rom read rom modules but do not allow sa block

Pls tell me how its possible to busy stop

Short tv9 + tv10 then power and wait until DSC DRD status is present

prashantasus wrote:Source of the post read rom read rom modules but do not allow sa block

Block module 30 access in ROM, restart the drive and upload Dir and loader into RAM, then solve Slow Responding.

Maxim_TS wrote:Source of the post

prashantasus wrote:Source of the post read rom read rom modules but do not allow sa block

Block module 30 access in ROM, restart the drive and upload Dir and loader into RAM, then solve Slow Responding.

Question ,
On what drives do you want us to block module 30 and why .Why does general blocking not work in these drives

prashantasus, have you tried something already?

Hello sir busy busy busy rom and last goto amnf
Sir how to access sa in hotswap and other idea ?

prashantasus wrote:Source of the post busy busy busy rom and last goto amnf

It looks like head issue. What in log after utility start? All ROM modules are good?

Rom modules are good.
After 2-3 minutes goto amnf.
Motor ic heat.
Only PCB attach drd DSC ready
Any idea sa access in hotswap

prashantasus wrote:Source of the post Any idea sa access in hotswap

Hot-swap doesn't work for this drive family usually.

In February I wrote to block module 30 access in ROM, then restart the drive and upload Dir and loader into RAM.
Have you tried it? What was the result?