PC-3000 Forum

Hello all, I have a 2TB WD here that a TA helped me with. I have to change back SA regions address since its shifted. NO Dir in HDD Ram, a module 02 error with LDR uploaded recommended. I'm still new to this but thought I would post to see if anyone can walk me through it. Thank you.
At first the drive was stuck in BSY state with no device ID. Changed heads with working donor and drive becomes ready.

Techno mode key
Techno mode key......................... : Ok


HDD Status sector....................... : Ok

RAM:
System controller (SoC)................. : 88i9045B0 0x(63B0)
HDD Info reading........................ : Ok
Heads number............................ : 8
Cyl Count............................... : 256

ROM:
Read ROM................................ : Ok
ROM Data size........................... : 512 Kb
Flash ROM dir reading................... : Ok (Active)
Flash ROM dir reading (Ext)............. : Ok
Modules directory address............... : 320 647
SA regions address...................... : shifted
SA regions address (RAM)................ : by default
Module 02 access........................ : Granted

SA SPT.................................. : 1945

SA Translator loading................... : Ok

ROM Modules:
ROM version............................. : 05.0QF
ROM F/W version......................... : 0005001M
Overlay F/W version..................... : 05.0QF
Servo F/W version....................... : 02.02

Heads configuration..................... : by map
Heads number............................ : 8
Heads number in use..................... : 8
Switched off heads...................... : No
Heads map............................... : 0,1,2,3,4,5,6,7

Relocations............................. : 0 (0)

Service area:
Power up log reading.................... : Ok
Dir data................................ : No
Permanent overlay....................... : No
CFG data................................ : No
SA dir reading (ID)..................... : Ok
Dir items loaded........................ : 463
No dir in HDD RAM found. To get access by ID to SA modules please uploadg dir to RAM

SA Access............................... : Copy 0,Copy 1

Configuration reading................... : Module 02 reading error: ABA 320 671 C:1(1) reading error Device Error Detected: "VSCE PERM OVL NOT LOADED. LDR Upload is recomended"

Drive power supply...................... : OFF

If SA is shifted, then it's normal not to have access to SA

If you want to get back SA access, you need to change the SA location back to its original value.
PC3000 does this automatically from here: Work with ROM>Allow SA Access and Restart HDD