PC-3000 Forum

HI
Model : WDC WD40NDZW-11MR8S1
Serial : WD-WX
Firmware : 02.01A02
Capacity : 4 TB (7 813 971 632)

The drive become ready instantly but no ID , then when i load loader in RAM drive read ID and drive become normal , all module ok, but no sector access, it's spglass2 so i must use original USB board, Can anyone tell me what is the reason drive not reading ID at once power up ?

Did you check the SA. If so were there any bad mods such as 02?

Hi


i checked all modules and all modules major and minors are completely ok.

can anybody have loader for WDC WD40NDZW-11MR8S1 ROM version............................. : 02.0AS