PC-3000 Forum

Hi

I was imaging this drive and it gave me an error. After power Off/ON I get this error:

Techno mode key
Techno mode key......................... : Ok

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 2
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 1480

ROM:
Read ROM................................ : Ok
ROM Data size........................... : 256 Kb
Read ROM................................ : Module ID 0B reading error; unexpected error: Data request error; unexpected error: SAT command error: Device Error Detected: "CA FLUSH ALL GOT CANCELED"

Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : Ok
SA Access............................... : NONE

Configuration reading................... : Module 02 not found
Module ID 109 reading error; unexpected error: Data request error; unexpected error: SAT command error: Device Error Detected: "CA FLUSH ALL GOT CANCELED"

What is this?
Thanks

Module ID 0B reading error;

Maybe SA address cant be known?

SA dir reading (ID)..................... : Ok

Does modules table from this look OK?

Rewrite 0B from backup, or from one in database of same FW. If not available, write any module and manually set to address it should be.