WD usb HDD wd10jmvw kernel mode

[mscerl]

Hi everyone
i connected the WD usb drive through SATA pins(by soldering the wires on the PCB)
when i start the utility, it connects in kernel mode!
what's the problem ?
How can i run it in normal mode?

Thanks

[Amarbir[CDR-Labs]]

Source of the post Hi everyone
i connected the WD usb drive through SATA pins(by soldering the wires on the PCB)
when i start the utility, it connects in kernel mode!
what's the problem ?
How can i run it in normal mode?

Thanks

Hi,
Before You Do Anything Could You Please Read the ROM Of This In USB Mode "Using Toshiba Com Port Adapter " And Program That Read Rom Into a SATA PCB And Try Running It Once .If Its Still In Kernel Mode It could Be A Firmware/Head Issue And We Will Tackle It Later ,First Try This

[mscerl]

OK, Thanks

[DataMedics]

Source of the post Hi everyone
i connected the WD usb drive through SATA pins(by soldering the wires on the PCB)
when i start the utility, it connects in kernel mode!
what's the problem ?
How can i run it in normal mode?

Thanks

Kernel mode means the SA hasn't fully loaded into the PCB RAM. It could be the result of bad heads, damaged firmware modules, or a lot of other things.

[Maxim_TS]

mscerl, how long the wires are? If they are longer than 1 inch, shorten them, and restart the drive.