PC-3000 Forum

hi to all
i have a h.d.d 250
fw:cc49
this is hard only bsy
but my access to module and Sysfile
i do edit id, edit id do it but when power off/on change edit id not do
output terminal

F3 T>
Rst 0x08M
Servo Processor Is Reset.
RW: Disc Ctlr Initialization Completed.
ExecuteSpinRequest
No HOST FIS-ReadyStatusFlags 2002A185
F3 T>V1
User Slip Defect List
log log log phys phys
LBA span cumm cyl hd sctr zn cyl sctr SFI PBA
0 0 0 0 0 0 0 0 0 4 0

Head 0: entries 1 slips 0
Total Entries 1 Total Slips 0

F3 T>V40
Nonresident GList 0 entries returned
Total entries available: 0
PBA Len Flags Phy Cyl Hd PhySctr SFI

i think not load translator
i do short pin
i do isolation
i do change PCB
but not work
sysfile 35 attach
please help

Possibly is translator issue, but you need to consider post processing defects before clearing - since sys files can read you should make full backup of all modules first

Double check that heads allow to write at all.
Modify 93 sys file then re-read it and check that all changes has been applied.
After that make backup of 28, 1B, 35 system files and try to regenerate translator.

thanks filip @ aj2008
i do repeat short pin
now h.d.d ok
very thanks