PC-3000 Forum

Hi Guys,

I got a ST4000LM016-1N2170 here. Drive gets DRD DSC and does ID fine with Model, Serial Capacity and all.
I know these drives have their ports locked, at least on my version of PC3K. I have tried to read Sys file 93 and clear media cache but every thing I try sends it to BSY.
Terminel starts like this:

Boot 0x80M
RECOV Servo Op=0095 Resp=0005[LBA=0x00000001]
(P) SATA Reset

RAW OFF
PASS
(DOS Table) Worst Count: 00001AC2 At SU: 001F026A
Last Used Segment Found:
MSP POR10
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
[BRO - 0002] 173484C0 - 17348F97
[BRO - 0002] 0772962F - 077297AC
(DOS) SU:00288318 Adjusted BRO: 00000C4318 - 00000C448F
[BRO - 0002] 000C4318 - 000C448F
[BRO - 0002] 07029B74 - 0702B3B3
PrgF
LED:0x000000BD FAddr:0x00009887

LED:0x000000BD FAddr:0x00009887

LED:0x000000BD FAddr:0x00009887


Any help is greatly appreciated.

Hi,
I am still not clear ,you were or were not able to read sys file 0x93

Hi,
Noop, Hav't gotten anything out of the drive yet. I am pretty sure that its a FW issue. Have you tried the Unlock Tech utility on the PC3K 6.1x release?

Hi,
As Stated By All TS Guys In Forums They Are Working Of To Unlock This Firmware,Even In 6.2X This Is Not Unlocked

Are these 'diagnostic port locked' ST4000LM016 drives unlockable yet with v 6.3?

This drive have crypto-signed ROM, as result impossible to read ROM for now.
Developers under active developing a possible solution.

locked yet this rom Acelab ?