PC-3000 Forum

Hi,
I have ST1000LX15 (Mobile HDD) Hard Disk not spinning. may be corruption in Rom Any one have any Solution Please help ....

Status register and terminal output will most likely give you a hint

bikram wrote:Source of the post Hi,
I have ST1000LX15 (Mobile HDD) Hard Disk not spinning. may be corruption in Rom Any one have any Solution Please help ....

Hello,
This is a SSHD ,Check Terminal And Post Result Also Status Registers

Boot 0x80M DensityList:0x0000
PrgF
LED:0x000000BD FAddr:0x000059D8

LED:0x000000BD FAddr:0x000059D8

LED:0x000000BD FAddr:0x000059D8

Try to shorting the pcb by instructing by manual...
i success & got the data 1000 GB..
once you go with solution for unlolck 00000CD process
First we have to get >T

when you got you will success.. i tried for 3 days to get >T & finally got it.
https://forum.acelab.eu.com/viewtop ... 4&p=37327#
Good Luck

bikram wrote:Source of the post Boot 0x80M DensityList:0x0000
PrgF
LED:0x000000BD FAddr:0x000059D8

LED:0x000000BD FAddr:0x000059D8

LED:0x000000BD FAddr:0x000059D8

Hello ,
Bad Media Cache According To My Experience

It´s not media cache issue.
It´s NAND issue. Ace doesn´t have a solution yet.

computershopee wrote:Source of the post Try to shorting the pcb by instructing by manual...
i success & got the data 1000 GB..

hello Sir does this solution work for ST2000LX001 too? i tried the official guide here https://blog.acelab.eu.com/how-to-fix-a ... -chip.html
with donor after Repeat the unlocking steps (1-6) i cannot enter the command OI1 ..... i will get LED:0x000000BD FAddr:0x000059D8 !again
and if i skip this command and Repeat the unlocking steps (7-9). i get Waiting drive spin up !
with original PCB the drive spins if i change to 82 34 56 78 but i cant enter the command OI1
ps can ou share the solution for unlolck 00000CD process ?

can somebody tell me which is the correct position for the read channell? i tried many times but is still get the error LED:0x000000BD FAddr:0x00008004

should i short before or after the tech Unlock Handshake"?
should i keep the position untill the drive get ready ? if the position is correct will the drive keep spinning or will stop spins?