ST4000LM016-1N2170 BSY

[protech]

Hi Guys,

I got a ST4000LM016-1N2170 here. Drive gets DRD DSC and does ID fine with Model, Serial Capacity and all.
I know these drives have their ports locked, at least on my version of PC3K. I have tried to read Sys file 93 and clear media cache but every thing I try sends it to BSY.
Terminel starts like this:

Boot 0x80M
RECOV Servo Op=0095 Resp=0005[LBA=0x00000001]
(P) SATA Reset

RAW OFF
PASS
(DOS Table) Worst Count: 00001AC2 At SU: 001F026A
Last Used Segment Found:
MSP POR10
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
[BRO - 0002] 173484C0 - 17348F97
[BRO - 0002] 0772962F - 077297AC
(DOS) SU:00288318 Adjusted BRO: 00000C4318 - 00000C448F
[BRO - 0002] 000C4318 - 000C448F
[BRO - 0002] 07029B74 - 0702B3B3
PrgF
LED:0x000000BD FAddr:0x00009887

LED:0x000000BD FAddr:0x00009887

LED:0x000000BD FAddr:0x00009887


Any help is greatly appreciated.

[Amarbir[CDR-Labs]]

Hi,
I am still not clear ,you were or were not able to read sys file 0x93

[protech]

Hi,
Noop, Hav't gotten anything out of the drive yet. I am pretty sure that its a FW issue. Have you tried the Unlock Tech utility on the PC3K 6.1x release?

[Amarbir[CDR-Labs]]

Hi,
As Stated By All TS Guys In Forums They Are Working Of To Unlock This Firmware,Even In 6.2X This Is Not Unlocked

[ThomasH]

Are these 'diagnostic port locked' ST4000LM016 drives unlockable yet with v 6.3?

[Filipp_TS]

This drive have crypto-signed ROM, as result impossible to read ROM for now.
Developers under active developing a possible solution.

[rickchbz]

locked yet this rom Acelab ?