PC-3000 Forum

Posted: **26.10.16, 19:11**

HI

I have patian hdd MQ01ADB100, 1TB disk. It was in dell inspiron laptop and laptop is burned (motherboard) with disk too. Disk wount start at all.
So I found similar disk MQ01ABD075, 750GB as a donor and swap electronics with my patient disk. I have transfered ROM chip from patient PCB on donor PCB.
Now disk powers up but I heard hard clicks and nothing hapens!
Did I used correct PCB of donor or I have to use from same model ad my patient? How to be sure that heads are bad too in this case?

Thanks

Posted: **26.10.16, 20:49**

emir_has wrote:Source of the post HI

I have patian hdd MQ01ADB100, 1TB disk. It was in dell inspiron laptop and laptop is burned (motherboard) with disk too. Disk wount start at all.
So I found similar disk MQ01ABD075, 750GB as a donor and swap electronics with my patient disk. I have transfered ROM chip from patient PCB on donor PCB.
Now disk powers up but I heard hard clicks and nothing hapens!
Did I used correct PCB of donor or I have to use from same model ad my patient? How to be sure that heads are bad too in this case?

Thanks

Hi,
If PCB no is same and you swapped the board it would be heads are bad too

Posted: **02.11.16, 20:08**

emir_has wrote:Source of the post Did I used correct PCB of donor

I don't know, are the PCBs numbered the same?

emir_has wrote:Source of the post How to be sure that heads are bad too in this case?

Usually before even powering on a drive damaged in a fire the inside should be inspected for heat damage. Could be melted plastic or any number of damaged components.

PC-3000 Forum

MQ01ABD100

MQ01ABD100

Re: MQ01ABD100

Re: MQ01ABD100