Toshiba 2.5 IDE correct FW, Capacity bt NO data in Extractor

[VaibhavS]

Hello All,

Model : TOSHIBA MK1234GAX
Serial : 77G3T7Z0T
Firmware : AC001AB
Capacity : 111.79 GB (234 441 648)

it opens busy.. after HDD ID option show exact Capacity and FW..

but after opening in data extractor terminal , No data structue is shown..
And then Hard and Soft reset started..Same with RAW recovery option too..

Its DRQ light green and then to make it ready , soft reset need to be done..

No Data shown in Data Extractor..

for Disk analysis option, drive goes in loop of soft and hard reset..

what to do in this condition ?

[VaibhavS]

CP Avalable............................. : 33,34,44,56,91,92,93,94,95,97,98,9A,9B,9C,9F,A2,A6,A7,AA,BB,C1,CC,DD

Soft reset ...
HDD ID reading.......................... : Ok
HDD ID writing.......................... : Ok
Modules checking
Module 33............................... : Ok
Module 34............................... : Ok
Module 44............................... : Ok
Module 56............................... : Ok
Module 91............................... : Ok
Module 92............................... : Ok
Module 93............................... : Ok
Module 94............................... : Ok
Module 95............................... : Ok
Module 97............................... : Ok
Module 98............................... : Ok
Module 9A............................... : Ok
Module 9B............................... : Ok
Module 9C............................... : Ok
Module 9F............................... : Ok
Module A2............................... : Ok
Module A6............................... : Ok
Module A7............................... : Ok
Module AA............................... : Ok
Module BB............................... : Ok
Module C1............................... : Ok
Module CC............................... : Ok
Module DD............................... : CP Reading error; unexpected error: Operation aborted