Page 1 of 1
WDC Question.
Posted: 17.04.18, 12:28
by MasterT
I have a WDC WD10PURX-64E5EY0 drive.
It starts in kernel mode and i have the folowing question.
What's the meaning of this line?
SA regions address...................... : spared
Is it normal for kernel mode start or it's something else ?
Thanks.
Re: WDC Question.
Posted: 18.04.18, 10:03
by northwind
No.
It means that the SA regions have been changed to look at one head.
Re: WDC Question.
Posted: 27.04.18, 03:24
by Trouse
This might seem like an easy question, but never have done it before: I have a drive showing only one region address (Head 1 @ 351,232 Region address and 169,164 for region size). Is there any way to know what the other region addresses should be? This is a recovery that went to another location before us, so were having to work with what theyve done. Thanks!
Re: WDC Question.
Posted: 27.04.18, 09:38
by AJ2008
Head0 is usually 0 in ROM Regions. Check module 2b or 20b on donor of same model and fw version to know for sure
Re: WDC Question.
Posted: 07.05.18, 06:09
by Amarbir[CDR-Labs]
MasterT wrote:Source of the post I have a WDC WD10PURX-64E5EY0 drive.
It starts in kernel mode and i have the folowing question.
What's the meaning of this line?
SA regions address...................... : spared
Is it normal for kernel mode start or it's something else ?
Thanks.
Well,
if one of the head sa area is not very good we can use this trick ,Tool is saying that this trick is currently applied to this drive