Other SSD
-
- Topics
- Replies
- Author
- Views
- Last post
-
- 13 Replies
- by hdrescue Author
- 47066 Views
- Last post
Ok too bad, I would need any confirmation if it's supported yet.
by MHS-Solutions View the latest post
06.11.25, 16:20
-
- 0 Replies
- by MHS-Solutions Author
- 75 Views
- Last post
Is there any compatible loader available for this device?
Controller.............................. : SM2258XT
SSD sta
by MHS-Solutions View the latest post
04.11.25, 15:24
-
- 5 Replies
- by gameboybin Author
- 3674 Views
- Last post
I have a similar case. My question is, if I transfer the chip to a working donor, will that work?
by LostDataSA View the latest post
26.10.25, 21:43
-
- 2 Replies
- by amnetdata Author
- 316 Views
- Last post
Got it, Thanks!
by amnetdata View the latest post
17.10.25, 22:37
-
- 2 Replies
- by harddisklagning Author
- 1815 Views
- Last post
Hi, sorry for the late reply.
The customer wanted to wait for this fall before we proceed, so there has not been any so
by harddisklagning View the latest post
10.09.25, 11:36
-
- 36 Replies
- by Roman_TS Author
- 132730 Views
- Last post
Fraser Corrance
Was it a Sandforce?
by osity View the latest post
29.08.25, 20:34
-
- 1 Replies
- by Viktor Author
- 322 Views
- Last post
Hello,
As a possible option, you can try to swap NAND chips to a normal M.2 NVMe PCB with the same CPU. Should work
by Roman_TS View the latest post
22.08.25, 10:21
-
- 2 Replies
- by emir_has Author
- 400 Views
- Last post
Thank you Roman
by emir_has View the latest post
13.08.25, 18:52
-
- 1 Replies
- by datadisk Author
- 353 Views
- Last post
Hello.
Safe Mode pins must be between T R and G points. Try T+R, or R+G or T+G combinations
by Roman_TS View the latest post
13.08.25, 10:31
-
- 4 Replies
- by chipnova Author
- 1930 Views
- Last post
Hello.
Silicon Power SP A55 could be based on any type of CPU Including Phison, Silicon Motion, SandForce, JMicron, Ye
by Roman_TS View the latest post
20.05.25, 09:47
-
- 4 Replies
- by jojo2012 Author
- 1533 Views
- Last post
Light reflow
by jojo2012 View the latest post
10.03.25, 11:14
-
- 1 Replies
- by recoverysystem Author
- 1111 Views
- Last post
Should be supported.
by Roman_TS View the latest post
27.01.25, 18:36
-
- 1 Replies
- by dekelpc Author
- 890 Views
- Last post
Hello. Unfortunately, there is no solution for current Marvell 88NV1120 controller. Probably it will appear in the futur
by Roman_TS View the latest post
18.11.24, 12:02
-
- 5 Replies
- by headcrash Author
- 4359 Views
- Last post
Every NAND memory chip has a special thermo-sensor inside. This sensor adjusts the voltage consumption for better writin
by Roman_TS View the latest post
14.11.24, 16:03
-
-
SM2259XT New Firmware, Loader needed in future SSD updates
Attachment(s) by gameboybin » 07.12.23, 02:40 - 7 Replies
- by gameboybin Author
- 22666 Views
- Last post
Make sure that all NAND chips IDs are reading fine. There could be a hardware problem with this SSD.
Also, you can try
by Roman_TS View the latest post
07.11.24, 08:52
-
-
- 3 Replies
- by ovidiui Author
- 1227 Views
- Last post
Thank you Roman_TS, d_d_recovery for your replies.
Roman_TS we're waiting for the next PC3k update to renew our support
by ovidiui View the latest post
25.10.24, 11:15
-
- 2 Replies
- by Mekanik Author
- 5398 Views
- Last post
i had a case like that
the ssd model was TLC SATA III 240 GB, its controller was asolid AS2258BN
it was recognized fo
by rickchbz View the latest post
06.09.24, 01:24
-
- 0 Replies
- by mostafa1 Author
- 1604 Views
- Last post
hello dear
i have an problem with this model of SM2259XT2 + SH25BFT8A1MLR (4PCS NAND)
can you help please
Selected f
by mostafa1 View the latest post
10.08.24, 13:37
-
- 1 Replies
- by pad-dataservice Author
- 1428 Views
- Last post
Pinout will not help you. But our adapter will
https://www.acelab.eu.com/news/the-new- ... -stock-now
by Roman_TS View the latest post
17.05.24, 12:22
-
- 0 Replies
- by cis_rec Author
- 1709 Views
- Last post
any one can help me with this please
i attached pics that explain the status
i see heat spots on nands flash in
by cis_rec View the latest post
09.05.24, 23:17
-
- 2 Replies
- by gterry Author
- 1383 Views
- Last post
Thanks Roman!
by gterry View the latest post
16.04.24, 14:21
-
- 1 Replies
- by Issam Author
- 5201 Views
- Last post
Hello!
At this moment, only ADATA SU635 / SU650 based on MAS1102A and MAS0902A are supported. Other brands are not.
ACE
by Roman_TS View the latest post
15.01.24, 12:42
-
- 2 Replies
- by gameboybin Author
- 18017 Views
- Last post
Samsung NAND chips - usually loaders are not working good with them.
by Roman_TS View the latest post
29.12.23, 13:58
-
- 3 Replies
- by Southman343 Author
- 13631 Views
- Last post
But there is no Sk Hynix Utility in PC-3000 SSD, and no available loaders for this type of CPU.
It's a BGA-SSD drive, w
by Roman_TS View the latest post
29.11.23, 08:13
-
- 2 Replies
- by gameboybin Author
- 13930 Views
- Last post
Thanks for the response Roman
by gameboybin View the latest post
22.11.23, 16:51
-
- 6 Replies
- by Issam Author
- 25277 Views
- Last post
We are working already.
by Roman_TS View the latest post
16.11.23, 12:41
-
- 5 Replies
- by oldman Author
- 11192 Views
- Last post
Thanks, Roman, good to know, checked the terminal many times and thought that maybe bad connection.
Phil
by oldman View the latest post
01.10.23, 00:38
-
- 3 Replies
- by gameboybin Author
- 11542 Views
- Last post
Then use Sandisk Utility for SM2246XT. In case of any trouble - ask TS dpt, we will guide you.
by Roman_TS View the latest post
18.08.23, 10:22
-
- 2 Replies
- by redlabs Author
- 4375 Views
- Last post
Hello. There is no good solution for this type of controller.
But WD Blue usually have not a firmware issue but a capac
by Roman_TS View the latest post
09.08.23, 18:18
-
- 1 Replies
- by AST770 Author
- 14769 Views
- Last post
Hello
Every single manufacturer who is dealing with Marvell controller is writing its own firmware for each new model o
by ACE_Admin View the latest post
27.07.23, 10:01
-
- 1 Replies
- by cis_rec Author
- 2865 Views
- Last post
SM2258XT is fully supported. Please make a ticket and we will guide you:
https://ts.acelab.eu.com/tickets/add/
by Roman_TS View the latest post
07.07.23, 10:15
-
- 9 Replies
- by AdasRip Author
- 15735 Views
- Last post
Due to the log info, NAND chips are not reading. Probably something bad with CPU. Try to swap the NAND chips:
https://b
by Roman_TS View the latest post
23.06.23, 18:29
-
- 2 Replies
- by gameboybin Author
- 7348 Views
- Last post
Hello,
At this moment ACELab engineers reach a great success in 88SS1093 Marvell controller research. As the result of
by Roman_TS View the latest post
23.04.23, 13:20
-
- 2 Replies
- by Batbold Author
- 4519 Views
- Last post
Thank you!
by Batbold View the latest post
10.02.23, 10:12
-
- 1 Replies
- by Continuum Author
- 4821 Views
- Last post
Hello.
When you power ON the drive, it must provide you ATA-registers info. DRD+DSC - means READY, drive ready to work.
by Roman_TS View the latest post
03.02.23, 08:38
-
-
Chinese Brands - Dominating Indian SSD Sales [New Chipsets]
Attachment(s) by Amarbir[CDR-Labs] » 05.07.22, 09:51 - 8 Replies
- by Amarbir[CDR-Labs] Author
- 33897 Views
- Last post
We have so many of these REALTEK SSDs. They're very - here in Nigeria, and People are buying it.
I have more than 1
by Bankole View the latest post
01.02.23, 09:58
-
-
- 5 Replies
- by jerema Author
- 6404 Views
- Last post
Hello, is there any solution for SANDISK X400 256GB, based on 88SS1074-BSW2?
by radovanhlavacek View the latest post
30.12.22, 08:46
-
- 1 Replies
- by datahelp Author
- 3485 Views
- Last post
Hello,
Every single manufacturer who is dealing with Marvell controller is writing its own firmware for each new model
by Roman_TS View the latest post
23.12.22, 09:28
-
-
WD 480GB M.2 SSD With Sandisk 20-82-00469-2 Controller
Attachment(s) by Amarbir[CDR-Labs] » 16.12.22, 06:00 - 8 Replies
- by Amarbir[CDR-Labs] Author
- 43933 Views
- Last post
Amazing ,
Thanks i will get this started soon after i get my payment .
by Amarbir[CDR-Labs] View the latest post
17.12.22, 16:02
-
-
- 2 Replies
- by datahelp Author
- 8064 Views
- Last post
OK, thanks..
by datahelp View the latest post
15.12.22, 10:31
-
- 2 Replies
- by jojo2012 Author
- 5970 Views
- Last post
Thanks so much Roman, I'll try that
by jojo2012 View the latest post
29.09.22, 23:25
-
- 7 Replies
- by davidswa1 Author
- 14538 Views
- Last post
By default, all working NVMe drives should be detectable on Portable III, but if you can't get ID, means that there is a
by Roman_TS View the latest post
01.09.22, 10:06
-
-
SSD KINGDIAN PORTABLE SSD 500gb sm2259xt Topic is solved
Attachment(s) by italyassistance » 25.08.22, 17:12 - 2 Replies
- by italyassistance Author
- 119493 Views
- Last post
Do u see ddrecovery?
by italyassistance View the latest post
25.08.22, 17:55
-
-
- 2 Replies
- by mojimorady Author
- 4950 Views
- Last post
I am very appreciative for the help @Roman .
very quick and useful response.
by mojimorady View the latest post
29.07.22, 09:03
-
- 3 Replies
- by oldman Author
- 3624 Views
- Last post
Seems that the NAND chips aren't in a good condition. Especially if the NAND chips produced by Sandisk (0x45 - ID byte)
by Roman_TS View the latest post
13.07.22, 10:30
-
- 7 Replies
- by Tweety Author
- 15049 Views
- Last post
Hello,
We research it, probably a solution will appear in the nearest future.
by Roman_TS View the latest post
20.02.22, 19:46
-
- 2 Replies
- by ovidiui Author
- 118555 Views
- Last post
Figured that might be the case. Just wanted to ask to make sure.
Thanks Roman for your answer.
Have a great week
by ovidiui View the latest post
06.12.21, 11:03
-
- 9 Replies
- by Amarbir[CDR-Labs] Author
- 14753 Views
- Last post
Hello all,
Does anyone know anything about 88NV1120 support?
I have a translator error - same pattern all over address
by igen View the latest post
12.10.21, 10:20
-
- 2 Replies
- by burchiam Author
- 4356 Views
- Last post
Thank you, will try over the next few days
by burchiam View the latest post
01.10.21, 07:55
-
- 10 Replies
- by rajax69 Author
- 15108 Views
- Last post
is there any way to get in this controller? the question is now 3 years ago, and still no solution for it?
by c.vogl@solution.at View the latest post
26.08.21, 18:48
Who is online
Users browsing this forum: No registered users and 4 guests
