Hard Disk Drives (HDD)
-
- Forum
- Topics
- Posts
- Last post
-
- 933 Topics
- 4105 Posts
-
Last post
Re: Boot Code: Can not get current address!
by Ayman View the latest post
11.08.24, 12:59
-
-
Western Digital
Subforums: WD Marvell, WD USB, WD Caviar Cyl 32, WD OLD, Archive
Moderators: Roman_TS, Maxim_TS, Sergey_TS, Garry_TS - 831 Topics
- 3856 Posts
-
Last post
Are the errors UNC errors?
by d_d_recovery View the latest post
02.10.24, 18:12
-
-
- 176 Topics
- 632 Posts
-
Last post
There are two pads on the left of pcb where you solder TX and RX.
by SGdata View the latest post
19.07.24, 17:13
-
-
IBM/Hitachi/HGST/Toshiba
Subforums: HGST/Toshiba (Arch ARM), IBM/Hitachi/HGST (Arch M24), Archive
Moderators: Maxim_TS, Filipp_TS, Sergey_TS, Garry_TS - 240 Topics
- 938 Posts
-
Last post
https://hex-serwis.pl/en/firmware
by HEX View the latest post
16.09.24, 22:10
-
-
- 146 Topics
- 597 Posts
-
Last post
Thanks for the reply, d_d_recovery.
Sector 0 is not readable.
Because the head clicks at startup.
It will be DRD,DSC in
by se134 View the latest post
23.08.24, 07:23
-
- 51 Topics
- 146 Posts
-
Last post
Hello,
I have MHV2040BH model drive that has pcb problem, does this drive has adaptive data in ROM
by KECIS View the latest post
13.06.23, 14:57
-
- 69 Topics
- 237 Posts
-
Last post
Thank you,
Heads are Dead
by O.S View the latest post
17.10.20, 00:59
-
- 6 Topics
- 19 Posts
-
Last post
Now I need to know how to calculate teh LBA when I do the translator rebuild from teh heads, cyliners and sectors.
I
by Continuum View the latest post
01.07.14, 07:09
-
-
HDD's resources exchange
A place where customers can exchange their HDD resources with each other
Moderators: Maxim_TS, Sergey_TS - 383 Topics
- 985 Posts
-
Last post
Thanks, I appreciate the help!
by Hddex View the latest post
17.08.24, 23:52
-
-
- 45 Topics
- 172 Posts
-
Last post
hello
by thanhtn View the latest post
13.09.24, 16:46
-
- 191 Topics
- 666 Posts
-
Last post
Re: wd1600js slow on heads 0 and 3
by cuumaytinh View the latest post
06.10.15, 20:17
Who is online
Users browsing this forum: No registered users and 1 guest